Knowledgebase
Knowledgebase: MOTA
Replacing the Top Rotor & Engine Gear
Posted by on 01 July 2013 01:26 PM

1.  To replace the top part with engine gear, please simply remove all screws "above" the gears on the helicopter.

2.  There should be about 20 screws total.

3.  The screwdriver that was included with the original spare parts pack can be used.

4.  Once all screws are removed, the gears can slide out, and be replaced.

5.  make sure the gears line up with the motor piece.

(7 vote(s))
Helpful
Not helpful

Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments:
© 2014 MOTA